Project 929rr
Posted: 31 Dec 2015, 15:00
Hi all... Im back
Bought Moz's 929rr and have started the tear down and planning the work.
As bought:
I've given her a wash and started to tear down some of the parts that need attention, one of which is the Yoshimura Rearsets....
They are bent (likely due to dropping and generally pretty ratted), ideally i'd like to straighten these out and then anodise them in black . They are actually very expensive and a cheaper set really isn't worth my time. Any ideas?
Also whilst removing these i managed to snap one of the bolts that hangs the bracket to the frame and also the master cylinder, again any ideas?
The plans then will be either new fairings or a repair/repaint job followed by either a 954 or rr8 tail.
So as it stands:
Bought Moz's 929rr and have started the tear down and planning the work.
As bought:
I've given her a wash and started to tear down some of the parts that need attention, one of which is the Yoshimura Rearsets....
They are bent (likely due to dropping and generally pretty ratted), ideally i'd like to straighten these out and then anodise them in black . They are actually very expensive and a cheaper set really isn't worth my time. Any ideas?
Also whilst removing these i managed to snap one of the bolts that hangs the bracket to the frame and also the master cylinder, again any ideas?
The plans then will be either new fairings or a repair/repaint job followed by either a 954 or rr8 tail.
So as it stands: