Hi guys I've recently acquired a 600f2 (1992) and I've read in various places about changing the rear end but no one really goes in to to much detail

I'm thinking of turning this bike into a streetfighter so I want to make it a single seat and put a better looking rear end on

Just haven't a clue what would go on without to much hassle as I've never welded in my life

Aby help would be muchly appreciated

I have a 600rr rear end on my F3

Purity14 wrote:I have a 600rr rear end on my F3

Hey purity.
Can you post a pic of your top yoke?

Yeah, what do you want to see?

I have this one to hand, if its my risers you want to see?

..excuse the frog - he was helping.

Purity14 wrote:I have a 600rr rear end on my F3

Did you need to do any mods to the subframe or did it go straight on? And could I be cheeky ad ask for a picture

Daveace22 wrote:

Purity14 wrote:I have a 600rr rear end on my F3

Did you need to do any mods to the subframe or did it go straight on? And could I be cheeky ad ask for a picture

Yes, you have to mod your subframe.
They do it all the time in America and it is well documented.
However you have to spend a long time lining things up otherwise it will just end up looking shit.

I don't run an undertail exhaust, I use a standard exhaust (not mounted yet in picture)
I use tool tubes instead, they are waterproof tubes that I keep spares/things in.

I still have little snaggy bits to go over and make better (like the rear indicator mounts etc)

Looks miles better than the f2 rear end that mate cheers for the info

Purity14 wrote:I have this one to hand, if its my risers you want to see?

..excuse the frog - he was helping.

Which top yoke is that?

Standard top yoke, dropped 25mm.
Attached to the fork legs are bolt on fork leg risers.

Saves me drilling the OEM top yoke!